Downs' Tube Puller

Tube Pullers are an internal expanding type grip for pulling tubes. with finished internal surfaces, through tube sheets. The puller exerts a uniform non-matring force on the inside of the tube. This unit is adjusted by means of an ordinary wrench on the expansion collar. It should be noted that these units are for finely finished tube, with little adjustment available. Therefore the exact Internal Diameter of the tube to be handled must be specified.

Item Number	Tube Internal Diameter	Weight
			10758-2.00	2"	4 lbs
			10758-2.25	2 1/4	4 lbs
10758-2.50	2 1/2	5 lbs
10758-2.75	2 3/4	5 lbs
10758-3.00	3	6 lbs
CONSULT FACTORY FOR OTHER AVAILABLE SIZES OR WHEN USED AS A LIFTING DEVICE.
Dimensions given are in round numbers. We reserve the right to make changes to our designs at any time that may not be reflected in the table. Please ask for a Certified Dimension Print for current dimensions.

The sizes and capacities listed above are a reference to the most common sizes of this equipment. If you have a different capacity, irregular size or some other need that must be met by our equipment, we will be happy to design one of these pieces of equipment to meet your special needs while also meeting or exceeding our interpretation of the appropriate ANSI / ASME. standards.

Improper use of lifting equipment may cause serious injury or death.
Only a Qualified Operator, as defined by the ASME B30.20 Standards, shall operate equipment.
Read and understand General Warnings before operating equipment.

Contacts