Series 112 Adjustable Compression Spreader Beam

Series 112

Load spreaders or lifting beams are used when loads need to be lifted on a single hoist but must be supported at two or more points.

Series 112 Adjustable Compression Spreader Beams are used when headroom is not a prioirty, but weight is. The reach of the beam can be adjusted by pulling a pin and sliding inner tube in or out. Then the pin is replaced into outer tube.

A bridle sling is used to attach to the beam. Oversized Swivel Hooks with latches are standard to allow for more room to insert slings. If price is of more concern than convenience, ask salesperson to quote with minimum hook size Sales@DownsCrane.com.

Special Fittings and arrangements are available. Please ask salesperson Sales@DownsCrane.com.

The sizes and capacities listed above are a reference to the most common sizes of this equipment. If you have a different capacity, irregular size or some other need that must be met by our equipment, we will be happy to design one of these pieces of equipment to meet your special needs while also meeting or exceeding our interpretation of the appropriate ANSI / ASME. standards.

Improper use of lifting equipment may cause serious injury or death.
Only a Qualified Operator, as defined by the ASME B30.20 Standards, shall operate equipment.
Read and understand General Warnings before operating equipment.

Copyright © 2018 · All Rights Reserved · Downs Crane & Hoist Company, Inc.
Designers and manufactures of "Below the Hook" material handling equipment.

Contacts